Using The Label Applications; Setting Default Label Properties - Dymo XTL 300 User Manual

Using the Label Applications

The label maker includes a number of label
applications that make it easy to create a label for
your specific job.
Label applications appropriate for the currently
inserted label cartridge will appear to the left of
those label applications that are not compatible.
A caution symbol
application and the current label cartridge are not
a match.
The following label applications are available for your specific labeling job and are
described in detail in this section:
Quick Cable Wrap
General Flag
You can create and save labels for applications that are not compatible with the
currently inserted label cartridge by removing the cartridge and leaving the label
compartment empty. However, make sure the correct label cartridge is inserted
before attempting to print.
This section describes each label application and the label properties you can
change to customize your label.

Setting Default Label Properties

Most label editors contain a wizard which steps you through the properties that
must be set each time you create a label. For labels you use frequently, you can
avoid stepping through the wizard by setting default properties for that label.
To set default label properties
Select the properties for a label application by stepping through the wizard.
1
Select Set as defaults.
2
Next time you select that label application, you will not have to set properties to
get started. You can change the properties for an individual label at any time by
selecting Properties.
You can clear any default label properties you set for a label application. See
Restoring the Label Application Default Settings on page 37.
®
13 XTL 300
User Guide
appears when a label
Patch Panel 110-block Laminated
Cable Wrap
Distribution Horizontal Heat-shrink
Panel Breaker
Terminal Asset
Block Tracking
Vertical Materials
Tube Breaker Management