Mirror; Cut Labels; Feed; Setting The Default Barcode - Dymo XTL 300 User Manual

A101 A101 A101 A102 A102 A102 A103 A103 A103
This setting is saved with your label file.
To turn off collation
Press and hold
1
Select Collate and then select Don't collate labels.
2
Select Done and then press
3

Mirror

The mirror option allows you to print the contents of your label
backwards, from right to left, as you would see the contents of
your label in a mirror.
This setting is not saved with your label file.
To print from right to left
Press and hold
1
Select Mirror and then select Mirror content.
2
Select Done and then press
3

Cut Labels

When printing multiple copies, the label maker prints all labels continuously so you
can cut at the end. A label separator cut mark is printed between each label to
show where each label should be cut.
You can change this setting so that the label maker will pause between each label
allowing you to cut before printing the next label.
To choose when to cut multiple labels
Press and hold
1
Select Cut labels.
2
Select one of the following:
3
• All labels (default)
• Each label
Select Done and then press
4

Feed

You may need to feed additional label material before you cut a label or if a label
does not advance from the label exit slot properly.
To feed the label
Press and hold
1
Select Feed to advance the label by 1/4" (6 mm).
2

Setting the Default Barcode

The default barcode type will be inserted automatically each time you insert a
barcode on a label. The factory default barcode type is Code 128.
®
36 XTL 300
User Guide
to display the print options menu.
.
to display the print options menu.
.
to display the print options menu.
.
to display the print options menu.
0 3 0 T L X