Connecting The Power; Charging The Battery; Removing And Replacing The Battery - Dymo XTL 300 User Manual

Connecting the Power

The label maker is powered by a rechargeable, lithium polymer (LiPo) battery.
The battery included with your label maker comes partially charged. For best
results, fully charge the battery before using the label maker for the first time.
See Power Status on page 10 for information about visually determining battery
charging status.

Charging the Battery

Fully charging a discharged battery will take approximately two and a half hours.
You can continue to work as long as the power adapter is connected.
Make sure to read the LiPo battery safety
precautions found on page 51.
To charge the battery
On the left side of the label maker,
1
gently lift and turn the connector
cover to expose the power connector.
See Figure 2.
Plug the power cord into the power
2
adapter. See Figure 3.
Plug the barrel end of the power
3
adapter into the power connector.
Power adapter
Plug the power cord into a power outlet.
4
The power status will show charging

Removing and Replacing the Battery

The LiPo battery is designed to provide years of service. In the unlikely situation
that you need to replace the battery, a replacement battery can be ordered from
www.dymo.com.
Make sure the power adapter and USB cable are disconnected before handling
the LiPo battery.
®
2 XTL 300
User Guide
Lift and turn
Power connector
Power cord
in the upper right corner of the display.
Figure 2
Figure 3