Cleaning The Cutter Blade; Cleaning The Sensors - Dymo XTL 500 User Manual

Cleaning the Cutter Blade

Clean the cutter blade each time you
replace the label cartridge.
To clean the cutter blade
Press the label compartment
1
release and lift the cover.
Remove the label cartridge.
2
Pinch the release lever on the
3
outside of the cutter blade and
pull the cutter blade straight up to
remove. See Figure 13.
.
Place the cutter blade on a flat surface
4
with the blade side facing up. See
Figure 14.
Use a cotton swab and alcohol to
5
clean both sides of the blade.
The cutter blade is extremely sharp.
Use caution when cleaning.
After cleaning the blade, insert the
6
cutter mechanism back into the label
maker and press into place.

Cleaning the Sensors

Several sensors inside the label
compartment need periodic cleaning to
remove dust and other particles that
may have accumulated.
To clean the sensors
Press the label compartment
1
release and lift the cover.
Remove the label cartridge.
2
Remove the cleaning tool from
3
inside the label compartment
cover.
Use the sponge end of the cleaning tool to gently wipe the sensors using an
4
up and down motion (not side to side). See Figure 15 for sensor locations.
™
48 XTL 500
User Guide
Cutter
blades
Sensors
Pinch and
pull up
Figure 13
Figure 14
Figure 15