Preparing The Audio Input System; Connecting A Microphone To The Mic In Connector; Connecting Microphones To The Audio In Connectors - Sony PDW-F800 Operation Manual

Preparing the Audio
Input System
Connecting a microphone to the
MIC IN connector
You can attach the ECM-680S stereo microphone
(not supplied) to the microphone holder of the
HDVF-20A viewfinder (not supplied).
1
Loosen the screw and open the
microphone holder clamp.
Microphone holder clamp
2
Place the microphone in the
microphone holder.
1 Wind the microphone spacer (sheet
type, supplied with the ECM-680S)
around the microphone, while peeling
off the protective sheets on both sides
of the microphone spacer.
2 Place the microphone in the holder so
that "UP" is at the top.
3 Close the microphone holder.
4 Tighten the screw.
On how to perform this operation, refer to the
operation manual for the microphone.
1
3
Plug the microphone cable into the MIC
IN connector, then set the AUDIO IN
2
switch for the channel on which you
want to record the audio from this
microphone to FRONT (for CH-1/
CH-2) or F (for CH-3/CH-4).
4
Secure the microphone cable with the
cable clamps.
Connecting microphones to the
AUDIO IN connectors
You can connect up to two monaural
microphones to the AUDIO IN CH1/CH2
connectors, using a CAC-12 Microphone Holder
(not supplied).
2
1
4 3

Preparing the Audio Input System

49