Table of Contents
Advertisement
KINO-DQM871 Mini-ITX SBC
Step 3:
Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-7.
Step 4:
To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.
4.8 External Peripheral Interface Connection
Devices can be connected to the external connectors. To install external devices, follow
the directions in the subsections below.
4.8.1 Audio Connector
The audio jacks on the external audio connector enable the KINO-DQM871 to be
connected to a stereo sound setup. To install the audio devices, follow the steps below.
Step 1:
Identify the audio plugs. The plugs on your home theater system or speakers
may not match the colors on the rear panel. If audio plugs are plugged into the
wrong jacks, sound quality will be very bad.
Step 2:
Plug the audio plugs into the audio jacks. Plug the audio plugs into the audio
jacks. If the plugs on your speakers are different, an adapter will need to be used
to plug them into the audio jacks.
Line Out port (Lime): Connects to a headphone or a speaker.
Microphone (Pink): Connects to a microphone.
Step 0:
Page 67
Advertisement
Table of Contents
