Table of Contents
Advertisement
WARNING:
The installation instructions described in this manual should be
carefully followed in order to prevent damage to the KINO-DQM871,
KINO-DQM871 components and injury to the user.
Before and during the installation please DO the following:
Read the user manual:
o
The user manual provides a complete description of the installation
instructions and configuration options.
Wear an electrostatic discharge cuff (ESD):
o
Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.
Place on an antistatic pad:
o
When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.
Turn all power off:
o
Make sure the product is disconnected from all power supplies and that
no electricity is being fed into the system.
Before and during the installation of the KINO-DQM871 DO NOT:
DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.
DO NOT use the product before verifying all the cables and power connectors
are properly connected.
DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.
Page 58
KINO-DQM871 Mini-ITX SBC
Advertisement
Table of Contents
