Using The Paper Basket (Sc-T7200 Series/Sc-T5200 Series/Sc-T3200 Series) - Epson SC-T7200 Series User Manual

SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
Cut Sheets
Cut sheets are automatically ejected to the rear,
where they can be removed by hand.
Poster Board
Poster board is partially ejected to the front.
Supporting the board with one hand to prevent it
falling, press the Z button and pull out the
board.
If the next job will not use poster board, lower all
the poster board supports. Leaving the supports
raised may cause paper to jam.
To lower the supports, grasp them as shown, pull
them diagonally downward, and then release.
D
Follow the on-screen instructions to load the
paper for the next job.
Basic Operations
Using the Paper Basket
(SC-T7200 Series/
SC-T5200 Series/
SC-T3200 Series)
The paper basket collects paper from the printer,
preventing it falling to the floor and becoming creased
or dirty.
The optional Stand (24) for the SC-T3200 Series comes
with a paper basket.
If one sheet is to be collected, paper up to the following
sizes can be collected regardless of the paper type.
Maximum size when one sheet is collected
SC-T7200
Series
SC-T5200
Series
SC-T3200
Series
When collecting one sheet, use the paper basket in the
standard position.
Adjusting the PositionU
page 47
Note:
Close the paper basket before printing banners or other
documents that exceed the maximum length. Before the
paper ejected from the printer touches the floor, we
suggest that you take it in both hands close to the paper
eject guides and continue to lightly support it until
printing is complete.
The basket can hold up to 20 sheets of the same size
when you print in line drawing mode to plain paper rolls
of the following sizes.
When the paper basket will collect paper continually,
change the position of the paper basket in accordance
with the paper size to be stored.
45
Paper Width Paper Length
About 1,118 mm / 44
inches
About 914 mm / 36 Approx. 1,189
inches mm
About 610 mm / 24
inches
"Adjusting the Position" on