Epson SC-T7200 Series User Manual page 33

SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
c
Important:
The commercially available media types, such as
those shown below, may not be cut cleanly by the
built-in cutter. Furthermore, cutting the following
media types may damage or reduce the lifetime of
the built-in cutter.
❏ Fine art paper
❏ Canvas
❏ Vinyl
❏ Matte poster board
❏ Adhesive paper
❏ Banner media
Cut these media types with commercially available
scissors or a cutter in the following manner:
Press the ) button. Keep the d button pressed to
feed the paper so that the cut location is below the
paper eject guide. Cut the paper using scissors or a
third-party cutter.
When you are using the SC-T7200D Series/
SC-T5200D Series, we recommend loading these
paper types in Roll 1.
Setting Auto Cut
You can specify the method either on the control panel
or the printer driver. Note, however, that the setting
selected with the printer driver takes priority when the
printer driver is used.
Note:
❏ Disable printer driver Auto Cut and printer Auto
Cut options when using the optional auto take-up
reel unit.
❏ It may take a while to cut the roll paper.
❏ If the cutting noise is bothersome, set Cutting Mode
to Silent.
"Setup menu" on page 146
U
Setting on the computer
Set Auto Cut from the Advanced tab - Roll Paper
Option in the printer driver's Properties (or Printing
preferences) screen.
Basic Operations
Setting from the printer
Use the l/r buttons of the control panel to select the /
tab and press the Z button or Menu button. In the
displayed Setup menu, select Printer Setup > Roll
Paper Setup > Auto Cut > On. For manual cutting,
select Off. The default setting is On.
"Setup menu" on page 146
U
Manual cut method
When Off is selected in the printer driver or Off is
selected for Auto Cut in the control panel, the paper can
be cut in any location after printing as described below.
Buttons that are used in the following settings
33