Epson SC-T7200 Series User Manual page 53

SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
E
Tape the end to the roll core.
Place tape (available from third-party suppliers)
at the center and then at the left and right ends.
F
Keep the d button in the control panel pressed
until you have fed enough paper for about three
wraps around the roll core.
G
Keep the Manual switch pressed to Forward to
wrap the paper three times around the core.
Basic Operations
After wrapping the paper around the core,
ensure that paper around the core is sufficiently
loose.
Note:
The tensioner supplied with the auto take-up reel
unit is used with some types of paper. Slacken the
paper and insert the tensioner near the center of the
paper as shown. See the following section for
information on paper that requires the tensioner.
"Epson Special Media Table" on page 196
U
H
Set the Auto switch to Forward.
Taking Up the Paper Printable Side In
For information on installing the roll core, see the Setup
Guide for the optional auto take-up reel unit.
53