Attaching The Paper - Epson SC-T7200 Series User Manual

SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
Backward : The roll is taken up with the printable
side in.
Forward : The roll is taken up with the printable
side out.
Off : The auto take-up reel unit does not
take up paper.
C
Manual switch
Selects the manual take-up direction.
The setting selected with the Manual switch takes
effect when the Auto switch is in the Off position.
Backward : The roll is taken up with the printable
side in.
The speed will increase after the button
is pressed for more than three seconds.
Forward : The roll is taken up with the printable
side out.
The speed will increase after the button
is pressed for more than three seconds.

Attaching the Paper

This section describes how to attach roll paper to the
auto take-up reel unit roll core.
The procedure varies with the take-up direction.
c
Important:
Before proceeding, select Off for Auto Cut. Using
the auto take-up reel unit when On is selected will
cause errors.
"Cutting the roll paper" on page 32
U
Taking Up the Paper Printable Side
Out
For information on installing the roll core, see the Setup
Guide for the optional auto take-up reel unit.
Basic Operations
Buttons that are used in the following settings
A
Set the auto take-up reel unit Auto switch to Off.
Plug the power cord into an outlet and confirm
that the power lamp lights.
B
Turn on the printer by pressing the P button.
C
Check that the roll paper is correctly loaded in the
printer.
D
Press the ) button on the control panel. Keep
the d button pressed until the end of the roll
reaches the roll core.
52