Epson SC-T7200 Series User Manual page 180

SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
Messages
Paper Width Error
Cannot switch to specified roll
paper because paper width is
different.
Continue to print with paper
currently loaded?
Paper Length Error
Insufficient remaining amount in
specified roll paper.
Continue to print with paper
currently loaded?
Roll Switch Error
Cannot switch roll paper
automatically.
Check printer settings.
Continue to print with paper
currently loaded?
Firmware Error
Firmware mismatch between PS3
Expansion Unit and printer.
Refer to manual for details.
Information
Cannot start copy because
non-supported media is loaded.
Refer to manual for details.
Information
Cannot send file.
Refer to manual for details.
Information
Cannot receive mail.
Refer to manual for details.
Problem Solver
What to do
The Source setting of the printer driver and the width of the roll paper loaded on the
printer are different.
If the Z button is pressed, the printer prints to the roll paper currently in use.
If the ( button is pressed, paper can be switched.
If you want to switch a roll paper even though it is a different paper width, open the Setup
menu, and then under Roll Switch Condition, change Paper Width to a setting other
than Width Match.
"Setup menu" on page 146
U
The remaining amount of roll paper loaded in Roll 1 and Roll 2 is shorter than the print
length, so the roll paper cannot be switched.
If the Z button is pressed, the printer prints to the roll paper currently in use.
If the ( button is pressed, paper can be replaced.
If you want to print even though remaining amount of roll paper is shorter than the print
length, open the Setup menu, and then under Roll Switch Condition, change Paper
Length to a setting other than Print Length.
"Setup menu" on page 146
U
If one of the following settings in the Setup menu is set as follows, roll paper is not
switched automatically.
❏
Auto Cut is Off.
❏
Auto Loading is Off.
If the Z button is pressed, the printer prints to the roll paper currently in use.
If the ( button is pressed, paper can be replaced.
To enable automatic switching of roll paper, change both settings above to On.
"Setup menu" on page 146
U
Operation is not possible because the versions of firmware of the optional Adobe
PostScript 3 Expansion Unit and the firmware of the printer are not compatible.
Update both to the latest firmware.
The latest firmware can be downloaded from the Epson website.
Load paper that supports large copy/large scan, and then print the copy/scan file again.
For paper that supports large copy/large scan, see the following.
"Epson Special Media Table" on page 196
U
If you tried to copy or send a large-scan image file to a shared folder, and this message
appears, check the following.
❏
Are the folder path, username, and password configured correctly in the shared
folder address setting of CopyCenter?
❏
Is there already a file with the same name in the save/transfer destination folder?
❏
Is there sufficient empty space in the save/destination folder?
If you tried to send an e-mail, and this message appears, ask your network administrator if
the e-mail settings have been configured correctly.
Ask your network administrator if the e-mail settings have been configured correctly.
180