Printable Area; Roll Paper Printable Area - Epson SC-T7200 Series User Manual

SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide

Printable area

This section describes the printable areas for the printer.
If the margin set in an application is larger than the
following setting values, sections beyond the specified
margins are not printed. For example, if 15 mm is
selected for the left and right margins in the printer
menus and the document fills the page, the 15 mm at the
left and right sides of the page will not be printed.

Roll Paper Printable Area

The gray area in the illustration below shows the
printable area.
When printing borderless on the left and right, the left
and right margins are 0 mm. When printing borderless
on all edges, all margins are 0 mm.
The arrow in the illustration indicates the direction of
the ejected paper.
254mm~1118mm
254mm~914mm
3mm/15mm
254mm~620mm
C
127mm
B
15m
A
*1 SC-T7200 Series/SC-T7200D Series
*2 SC-T5200 Series/SC-T5200D Series
*3 SC-T3200 Series
*4 If Banner is selected for Roll Paper Option in the
printer driver Advanced tab, the top and bottom
margins are 0 mm.
Margins for roll paper depend on the option selected for
Roll Paper Margin in the menus, as shown in the table
below.
Basic Operations
1
2
3mm/15mm
3
3mm/15mm
4
D
4
3~45mm
Roll Paper Margin SettingsU
page 146
indicates factory default settings.
Roll Paper Margin
Parameter
Normal
Top15mm/Bottom15mm
Top35mm/Bottom15mm
Top45mm/Bottom15mm
3 mm
15 mm
* When Normal is selected, the value for
for the following paper.
Premium Glossy Photo Paper (250)/Premium
Semigloss Photo Paper (250)/Premium Luster
Photo Paper (260)/Premium Semimatte Photo
Paper (260)
When the following media are used in CAD / Line
Drawing mode, the value for
Singleweight Matte Paper
c
Important:
❏ Printing is distorted when the trailing edge of
the roll paper comes off the core. Make sure the
trailing edge does not come inside the printing
area.
❏ The print size does not change even when the
margins are changed.
63
"Setup menu" on
Margin Values
*
A,C=15 mm
B,D=3 mm
A,C=15 mm
B,D=3 mm
A=35 mm
C=15 mm
B,D=3 mm
A=45 mm
C=15 mm
B,D=3 mm
A,B,C,D=3 mm
A,B,C,D=15 mm
A
is 20 mm
A C
is 3 mm.