Tv Signal Amplifier; Cable Tv And Satellite Connections; Tv Digital Satellite System Wiring - Winnebago Journey Manual

Hide thumbs Also See for Journey:
Table of Contents

Advertisement

NOTE: Refer to television manufacturer's
instructions to scan for available
channels.
Further Information
See the antenna manufacturer's user guide
provided in your InfoCase for complete operating
and maintenance information.

TV SIGNAL AMPLIFIER

The TV Signal Amplifier is built into the
antenna and can be turned on or off with a power
switch located on a switchplate in the overhead
compartment above the entrance door.
An indicator light will illuminate when the
switch is on and the signal amplifier is active.
TV Signal Amplifier Power Switch
(Located in overhead compartment
above entrance door)
-Typical View
CABLE TV AND SATELLITE
CONNECTIONS
(Input)
The Cable Television and Portable Satellite
Dish Connections are located in the utility
compartment.
The input lines can be routed through the
hatch in the bottom of the compartment so the
door can remain shut while connected.
Power
Switch
Cable TV and Satellite Dish Connections
(Located in utility compartment)
TV DIGITAL SATELLITE
SYSTEM WIRING
Your coach is pre-wired for installation of a
digital satellite TV system. Coaxial cable and
high definition component cable connections are
available to hook up your satellite receiver and
are located in the overhead cabinet above
entrance door (remove panel to access).
A second connection may be included inside a
cabinet in the bedroom for the rear TV (if
equipped).
See your authorized Winnebago Industries
dealer for proper installation and sealing of roof
mounted components.
To Access Interior Satellite Dish
Connections
Turn each access panel cover latch (located in
the overhead compartment above entrance
door) "counter-clockwise" completely until
you come to a stop.
SECTION 8 –
ENTERTAINMENT
®
8-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

2013 meridian

Table of Contents