Tv Antenna - Digital - Winnebago Journey Manual

SECTION 8 –
ENTERTAINMENT
2. Pull the TV out and pivot to desired position.
3. Rotate TV back to center position and press
straight back towards wall. You will hear a
"click" when the TV is secured into locked
position.
Further Information
See the television manufacturer's user guide
provided in your InfoCase for complete operating
instructions.

TV ANTENNA - DIGITAL

®
(Jack Digital HDTV Over-the-Air
Antenna)
Your coach is featured with a digital antenna,
which provides crystal clear digital HD reception
of over-the-air channels in addition to superior
broad reception range.
The digital antenna is equipped with a built-in
amplifier for maximum VHF and UHF
programming.
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
Operating the Digital Antenna
1. Turn the Digital Antenna Power Switch ON.
8-6
Digital Antenna Power Switch
(Located in an overhead cabinet or
mounted on a wall near the TV)
2. Turn ON the Signal Meter Power switch
(located on the side of the Signal Meter).
• Signal Meter
Power Switch
• Attenuator
Dial
• Release
Button
Digital Antenna Signal Meter
(Located on ceiling)
3. Rotate the Attenuator Dial fully
CLOCKWISE.
4. Press Release Button on the Rotational Knob
and rotate antenna (until maximum number of
LED lights illuminate on the Signal Meter).
NOTE: LED lights will illuminate from left to
right. All LED lights may not illuminate,
depending on signal strength.
5. Rotate Attenuator Dial COUNTER-
CLOCKWISE until the last illuminated LED
light flickers.
6. Rotate antenna to illuminate the last flickering
LED light.
7. Repeat Steps 5 and 6 to pinpoint signal
reception.
• Rotational Knob
(arrow indicates
which direction
antenna is pointing)