Compartment Lights Switch; Power Awning - Winnebago Journey Manual

SECTION 12 –
MISCELLANEOUS
COMPARTMENT LIGHTS
SWITCH
The Compartment Lights switch powers the
lights inside of the compartments. This switch is
located near the entrance door.
• Press the switch UP (On) to supply power to
the compartment lights.
• Press the switch DOWN (Off) to disable
power to the compartment lights.
NOTE: The Compartment Lights switch provides
power to the compartment lights. You
must manually turn each individual
compartment light on or off inside of the
compartments.
We recommend turning this switch OFF when
the coach is not in use to avoid battery drain if a
compartment light is left on accidentally.

Compartment Lights Switch

(Located near entrance door)
-Typical View

POWER AWNING

Your coach is equipped with entry door and
patio power awnings to provide protection
against outdoor elements, such as sun, rain, and
wind.
The awning control switches are located on
the switch panel just inside the entrance door.
12-10
Awning Control Switches
(Located near entrance door)
-Typical View
Patio Awning Operation
1. Turn the Awning Power switch ON.
2. Use the Patio Awning switch to extend or
retract the awning as desired.
3. Set the Awning Sensitivity switch to the level
desired.
Power Switch
• Power ON - The On position activates the
Patio Awning switch and the Auto-Retract
system as well as provides power to the
awning.
• Power OFF - The Off position shuts down the
system. The awning cannot be extended or
retracted in this mode. The Auto-Retract
system is also disabled.
Wind Sensor Auto-Retract Feature
If the Wind Sensor is activated, the system
will automatically retract the patio awning during
windy conditions. Sensitivity threshold is set on
the control panel.
Wind Speed Switch
(High/Low)
Low requires the least amount of motion
before automatically closing the awning. High
requires more motion before the system