Table of Contents
Advertisement
SECTION 8 –
ENTERTAINMENT
•Signal Meter
Power Switch
•Release
Button
Digital Antenna Signal Meter
(Located on ceiling)
3. Rotate the Attenuator Dial fully
CLOCKWISE.
4. Press Release Button on the Rotational Knob
and rotate antenna (until maximum number of
LED lights illuminate on the Signal Meter).
NOTE: LED lights will illuminate from left to
right. All LED lights may not illuminate,
depending on signal strength.
5. Rotate Attenuator Dial COUNTER-
CLOCKWISE until the last illuminated LED
light flickers.
6. Rotate antenna to illuminate the last flickering
LED light.
7. Repeat Steps 5 and 6 to pinpoint signal
reception.
NOTE: Refer to television manufacturer's
instructions to scan for available
channels.
Further Information
See the antenna manufacturer's user guide
provided in your InfoCase for complete operating
and maintenance information.
8-4
•Attenuator Dial
•Rotational Knob
(arrow
indicates which direction
antenna is pointing)
TV SIGNAL AMPLIFIER
The TV Signal Amplifier is built into the
antenna and can be turned on or off with a power
switch.
An indicator light will illuminate when the
switch is on and the signal amplifier is active.
TV Signal Amplifier Power Switch
(Located in an overhead cabinet or mounted
on a wall near the TV)
-Typical View
TV DIGITAL SATELLITE
SYSTEM WIRING
Your coach is pre-wired for installation of a
digital satellite TV system. Coaxial cable and
high definition component cable connections are
available to hook up your satellite receiver and
are located in the entertainment center cabinet.
A second connection may be included inside a
cabinet in the bedroom for the rear TV (if
equipped).
See your authorized Winnebago Industries
dealer for proper installation and sealing of roof
mounted components.
• Power
Switch
®
Hide quick links:
Advertisement
Table of Contents
