Cb Radio Power Wiring; Parking Brake - Winnebago Journey Manual

Radio Power Switch
The Radio Power switch lets you connect the
dash radio to the coach batteries with the ignition
switch turned off for listening while parked. This
prevents accidental draining of the chassis
battery with prolonged use of the radio.
NOTE:The House/Coach Battery Disconnect
switch must be ON while listening to the
dash radio because the audio relay is
powered by house batteries. If the House/
Coach Battery Disconnect switch is OFF,
the speakers will not emit sound.
Radio Power Switch
(Located on dash)
• Press HOUSE to listen to the radio while
parked without the ignition key on.
• Press ENGINE ("ENG") to listen while driving.
Further Information
See the manufacturer's user guide provided in
your InfoCase for complete operating
instructions.

CB RADIO POWER WIRING

Your coach is pre-wired for CB radio power
connection. The wires are located beneath the
dash to the left of the steering wheel.
Look for a pair of wires - yellow (+) and white
(-) with connectors and flag labels suspended
from the wiring harness.
DRIVING YOUR MOTOR HOME
CB Power Wires
(in plastic sheath)
Typical View - your coach may differ

PARKING BRAKE

®
Freightliner Chassis
Parking Brake Knob
-Typical View
• Pull to apply
• Push in to release
Use the parking brake knob to apply the park
brake whenever the vehicle is parked.
Never try to drive the vehicle with the parking
brake applied. This can cause excessive wear on
the brakes and may damage the transmission.
NOTE: It is normal to hear an occasional burst
of air pressure from the rear of the
vehicle. This is an automatic moisture
purging feature of the air brake system.
See the Brakes section of your chassis
manual for instructions on periodic
draining of brake air tank.
SECTION 3 –
3-13