Entertainment; Hdmi Video Selection System - Winnebago Journey Manual

SECTION 8 – ENTERTAINMENT
HDMI VIDEO SELECTION
SYSTEM
The HDMI Video Selection System allows
you to watch high definition video from multiple
sources on multiple TV's at the same time. You
can select either Home Theater, Satellite
Receiver 1, Satellite Receiver 2, or Auxiliary.
TVs connected to this system are the Lounge
TV, 2nd Lounge TV (if equipped), Bedroom TV,
and Exterior Entertainment Center TV.
NOTE: Red lights that are illuminated on the
HDMI Video Selection System and the
Secondary Source Selector indicate that
video sources are active.
Blue lights that are illuminated indicate
the selected video source.

HDMI Video Selection System

(Located in front passenger overhead cabinet)
NOTE: There may be a slight delay when
changing sources. Winnebago
®
Industries recommends setting each
component to a maximum video output
resolution of 1080i for proper operation.
HDMI Video Selector Control
(Located in your InfoCase Box)
• Used to control main HDMI Video
Selection System only
Secondary Source Selector
A Secondary Source Selector is provided at
each TV for your convenience. Press the Select
button to toggle to preferred source.
Secondary Source Selector
(Located near each TV)
To Watch Satellite TV
• Connect Satellite Receiver to the Accessory
Connection Cable (Satellite Receiver 1 or 2.)
These cables are located in a front overhead
cabinet or near the lounge TV, depending on
model.
Accessory Connection Cables
* Satellite Receiver 1 and Satellite Receiver 2
(Located in a front overhead cabinet or
near the lounge TV, depending on model)
NOTE: Auxiliary AV Component Cable not provided.
• Power "ON" TV, HDMI Video Selection
System, and Satellite Receiver.
• Determine which TV you want to use (e.g.
BEDROOM for bedroom TV) and select
"Satellite Receiver 1" from the HDMI Video
Selection System (or the HDMI Video
Selector Control or the Secondary Source
Selector).
8-1