Power Roof Ventilator - Winnebago Journey Manual

Horizontal Slider Windows
Swing the latch handle straight out or up
(depending on the style of window). Grasp the
sliding window edge frame and slide the window
to the side. Ensure the latch is open before trying
to slide the window closed.
Vertical Slider Windows
Vertical windows have spring-loaded catches
on both sides of the window that pop out to hold
the window in its fully raised position. Press the
catches outward toward the frames while
lowering the window.

POWER ROOF VENTILATOR

Lounge, Galley, or Bath Area
–If Equipped
The 3-speed turbine vent is controlled by a
switch on the wall to raise or lower the dome.
The turbine fan will start automatically as the
vent is raised, and stop as the vent is lowered.
Fan Power
Fuse
Switch
Power Roof Ventilator
To Operate Ceiling Ventilator
1. Press the wall switch to raise the dome about
3" or more to allow the turbine fan to operate.
(A built-in safety switch will not let the fan
motor run unless the dome is partially open).
2. The turbine fan will start automatically as the
vent dome is raised and stop as the vent dome
is lowered and closed. (Fan Speed knob up on
the ventilator frame must be in a position
other than 0-Off).
3. Turn the Fan Speed knob to the desired level
(1-Low, 2-Med, 3-Hi).
4. Open a window or door to provide airflow.
Direction of airflow is determined by which
window or door is opened.
NOTE: For best results, close all other roof
vents, windows, and doors, then open
one (1) window the farthest distance
from the roof ventilator. The fan speed
selector allows you to control the amount
of circulation you need at any time.
5. If you want the vent dome raised without the
fan running, turn the Fan Speed knob to 0-Off .
NOTE:In event of power failure, the ventilator
dome may be opened or closed manually
using the Dome Crank knob.
SECTION 12 –
MISCELLANEOUS
Fan Speed
Selector
Dome Crank
12-13