Chassis Service And Maintenance; Chassis Fuses And Relays - Winnebago Journey Manual

SECTION 11 –
MAINTENANCE AND STORAGE
16. Check tires for proper cold inflation pressure.
See Vehicle Certification Label in
Introduction section.
17. After washing accumulated winter grime
from the vehicle, it is important to carefully
inspect the seams and sealants for separation
or cracks that may have appeared around the
window frames, vents, and any other joints.
See Sealants – Inspection and General
Information at the beginning of this section.
Re-sealing is quite simple and the material is
quickly and easily applied. Appropriate
compounds are available from your dealer.
See Sealants – Recommended Application
page in the Supplement Manual provided in
your InfoCase.
Also inspect weather seals around doors, etc.,
and if necessary, have a dealer replace
immediately.
Ice Maker Start-Up
–If Equipped
1. Close all drain valves.
2. Turn the water supply on.
NOTE: Before turning the water supply on,
assure that the water faucet filter is in
place and that the water shut-off valve
(typically located inside galley cabinet
beneath sink) is OPEN.
3. Be sure the ice bin is in place and the
automatic shutoff arm is down.
4. Let the refrigerator cool down to ice making
temperature. Remember, this can take up to 24
hours.
5. Let the ice maker cycle and dump the first
batch of ice.
CHASSIS SERVICE AND
MAINTENANCE
Consult the appropriate sections in your
chassis manual for specific information
regarding operating safety, service
recommendations, and maintenance schedules
for the chassis section of your vehicle.
11-12

CHASSIS FUSES AND RELAYS

®
-Freightliner Chassis
Chassis and dash component fuses and relays
are located in the 12-volt electrical compartment
at the left front of the coach.
Automotive Fuses (cover removed)
Fuse Diagram (inside of cover)
See the chassis manufacturer's fuse allocation
chart on the inside of the fuse block cover.