Alto-Shaam ASF-75E Installation Operation & Maintenance page 21

P R O G R A M M I N G T H E C O N T R O L
5. Choose the correct melt cycle for your frying compound. The melt cycle will appear in the L E D as
" C Y L " or " C Y S " . " C Y L " is for liquid frying compounds such as oil and " C Y S " is for solid frying
compounds such as shortening. Do not choose " C Y 0 " .
• Scroll to change melt cycles by pressing
• Press TWICE to accept the new setting and proceed to the lock.
Do not press just once and change the " g A S " or " E L E C " setting.
NOTE:
6. Lock or unlock the Control Programming. " L o C " or " U L o C " will appear in the L E D display.
" L o C " will prohibit unqualified personnel (without the password) from entering Control
Programming. " U L o C " will leave Control Programming unlocked.
• Scroll to change lock condition by pressing
• Press to accept the new setting and proceed to select °F or °C.
7. Select °F or °C for the temperature display. " F " or " C " will appear in the L E D display. " F "
will cause the L E D to display Fahrenheit. " C " will cause the L E D to display Celsius.
• Scroll to change from °F to °C by pressing
• Press to accept the new setting and proceed to restart Control Programming sequence or press
and hold
At any point in the sequence, pressing and holding
Programming.
NOTE:
O P E R A T I N G I N S T R U C T I O N S
BASIC CONTROL
This section is provided for the assistance of qualified
personnel only and is not intended for use by
untrained or unauthorized personnel.
for one second to exit Control Programming.
# 8 3 5 1 • A S F - 7 5 E E l e c t r i c F r y e r O p e r a t i o n & C a r e M a n u a l • 1 9
or .
or .
or .
for one second will exit Control