Alto-Shaam ASF-75DS Installation & Maintenance Instructions Manual
Alto-Shaam ASF-75DS Installation & Maintenance Instructions Manual

Alto-Shaam ASF-75DS Installation & Maintenance Instructions Manual

Fryer dump station
Hide thumbs Also See for ASF-75DS:

Advertisement

Quick Links

F R Y E R D U M P S T A T I O N
®
MODELS
AS F-75DS
AS F-60DS
• I N STALLATION
• OPERATION
• MAI NTENANCE
W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA
PHONE: 262.251.3800 • 800.558.8744
/
FAX: 262.251.7067 • 800.329.8744
.
.
.
USA
CANADA
U
S
A
ONLY
www.alto-shaam.com
M N - 2 8 6 2 0 • 0 7 / 0 8
.
.
.
P R I N T E D I N U
S
A

Advertisement

Table of Contents
loading

Summary of Contents for Alto-Shaam ASF-75DS

  • Page 1 W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA PHONE: 262.251.3800 • 800.558.8744 FAX: 262.251.7067 • 800.329.8744 CANADA ONLY www.alto-shaam.com M N - 2 8 6 2 0 • 0 7 / 0 8 P R I N T E D I N U...
  • Page 2 Additional model. Contact the Alto-Shaam service manuals are available from the Alto-Shaam department if you have any questions concerning service department. installation, operation, or maintenance.
  • Page 3: Safety Procedures And Precautions

    SAFETY PROCEDURES AND PRECAUTIONS Knowledge of proper procedures is essential to the 1. This appliance is intended to cook, hold or safe operation of electrically and/or gas energized process foods for the purpose of human equipment. In accordance with generally accepted consumption.
  • Page 4: Specifications

    Electrical cord 150° 33-5/8" (854mm) 23-1/4" (590mm) 15-3/4" (400mm) for ASF-60DS 37-7/8" (961mm) for ASF-75DS H x W x D: EXTERIOR ASF-60DS DIMENSIONS 61-15/16" x 15-3/4" x 33-5/8" (1573mm x 400mm x 854mm) 36" (915mm) unit height without infrared warmer ASF-75DS 61-15/16"...
  • Page 5 I N S T A L L A T I O N N G E R N G E R IMPROPER INSTALLATION, AVERTISSEMENT : UNE INSTALLATION, ALTERATION, ADJUSTMENT, UN AJUSTEMENT, UNE ALTÉRATION, UN SERVICE OU UN ENTRETIEN NON SERVICE, OR MAINTENANCE COULD CONFORME AUX NORMES PEUT CAUSER RESULT IN SEVERE INJURY, DEATH DES DOMMAGES À...
  • Page 6: Installation

    I N S T A L L A T I O N It is the responsibility of the installer to verify LEVELING: Make certain that this dump station installation is in the fryer is positioned firmly compliance with the specifications listed in this on all four supporting casters.
  • Page 7 I N S T A L L A T I O N VENTILATION: NSTALLATION AIR VENTILATION REQUIREMENTS AND SERVICE WORK MUST BE IN ACCORDANCE WITH ALL LOCAL CODES AND MUST BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN An adequate ventilation system is required for commercial cooking equipment. Information may be obtained by writing to the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
  • Page 8: Restraint Requirements - Mobile Equipment

    I N S T A L L A T I O N RESTRAINT REQUIREMENTS — MOBILE EQUIPMENT The dump station must be supplied with a connector that complies with all state and local installation codes. Any appliance that is not furnished with a power supply cord but that includes a set of casters must be tethered.
  • Page 9 CSA C22.1, Canadian Electrical Code Part 1 or ELECTRICAL CONNECTIONS MUST local codes. BE MADE BY A QUALIFIED SERVICE TECHNICIAN IN ACCORDANCE WITH APPLICABLE ELECTRICAL CODES. & ELECTRICAL • ASF-60DS & ASF-75DS VOLTAGE PHASE CYCLE AMPS CORD PLUG 5-15P NEMA...
  • Page 10: Panel Identification

    O P E R A T I N G I N S T R U C T I O N S PANEL IDENTIFICATION ³ C O N T R O L PA N E L I D E N T I F I C AT I O N 1.
  • Page 11: Cleaning And Maintenance

    C A R E A N D C L E A N I N G CLEANING & MAINTENANCE N G E R DISCONNECT UNIT FROM POWER SOURCE BEFORE CLE NING OR SERVICING. THOROUGHLY CLEAN DAILY The cleanliness and appearance of this unit 4.
  • Page 12: Troubleshooting

    T R O U B L E S H O O T I N G T R O U B L E S H O O T I N G PROBLEM SOLUTION Unit does not power on • Ensure unit is plugged securely into outlet. •...
  • Page 13 S E R V I C E PART NO DESCRIPTION QTY UNIT PART NO DESCRIPTION QTY UNIT SC-2661 SCREW, 10-32 X1/2, NF PHIL 5008128 PANEL, LEFT SIDE 5007076 KETTLE ASSEMBLY ASF-60DS 5008127 PANEL, RIGHT SIDE SC-22284 SCREW, M6 X 16 HEX S/S HD CS-28098 CASTER, FRONT LH, SWIVEL (NOT SHOWN)
  • Page 14 S E R V I C E Parts 1 - 28 10, 11 & 12 F r y e r D u m p S t a t i o n O p e r a t i o n & C a r e M a n u a l • 1 3...
  • Page 15 F r y e r D u m p S t a t i o n O p e r a t i o n & C a r e M a n u a l • 1 4...
  • Page 16 F r y e r D u m p S t a t i o n O p e r a t i o n & C a r e M a n u a l • 1 5...
  • Page 17: Transportation Damage And Claims

    ALTO-SHA AM, INC. RECORD THE MODEL AND SERIAL NUMBER OF THE APPLIANCE FOR EASY REFERENCE. ALWAYS REFER TO BOTH MODEL AND SERIAL NUMBER IN ANY CONTACT WITH ALTO-SHAAM REGARDING THIS APPLIANCE. Model: Date Installed:...

This manual is also suitable for:

Asf-60ds

Table of Contents