Yealink SIP-T48G Administrator's Manual page 479

pass configuration parameters such as IPv6 network addresses to IPv6 nodes. It
offers the capability of automatic allocation of reusable network addresses and
additional configuration flexibility. This protocol is a stateful counterpart to "IPv6
Stateless Address Autoconfiguration", and can be used separately or in addition to
the stateless autoconfiguration to obtain configuration parameters.
Note
Stateful DHCPv6 address assignment method feature is only applicable to
SIP-T48G/T46G/T29G IP phones.
If the IP phone enables the SLAAC and DHCPv6 features simultaneously, the IP phone will
obtain the IP address via SLAAC and obtain other network parameters via DHCPv6.
Procedure
IPv6 can be configured using the configuration files or locally.
Configuration File
Local
<MAC>.cfg
<y0000000000xx>.c
fg
Web User Interface
Phone User
Interface
Configuring Advanced Features
Configure the IPv6 address
assignment method.
Parameters:
network.ip_address_mode
network.ipv6_internet_port.type
network.ipv6_internet_port.ip
network.ipv6_prefix
network.ipv6_internet_port.gateway
network.ipv6_icmp_v6.enable
Configure the IPv6 static DNS
address.
network.ipv6_primary_dns
network.ipv6_secondary_dns
Configure the IPv6 static DNS.
Parameter:
network.ipv6_static_dns_enable
Configure the IPv6 address
assignment method.
Configure the IPv6 static DNS.
Navigate to:
http://<phoneIPAddress>/servlet?p
=network&q=load
Configure the IPv6 address
assignment method.
Configure the IPv6 static DNS.
465