Table of Contents
Advertisement
6. For a 5.25-inch drive, install a retainer bracket on the side of the drive.
7. For a 3.5-inch drive, install the drive into the Universal Adapter Bracket, 5.25 to
8. Install the drive into the bay until it snaps into position or for the adapter
9. Continue at "Connecting drives" on page 20.
Installing a hard disk drive in bay 3
1. Remove the computer cover. See "Removing the cover" on page 10.
18
User Guide
v If you are installing an additional optical drive, set it as a slave device.
v If there is a combination of optical and parallel ATA hard disk drives in bays
1 and 2, set the hard disk drive as a master device and the optical drive as a
slave device.
Refer to the documentation that comes with your drive for master/slave
jumper information.
3.5-inch.
bracket, install the screws that secure the bracket in the bay.
Advertisement
Table of Contents
