Resetting The Server; Forced Shutdown - NEC EXPRESS5800/120Re-2 Service Manual

Resetting the Server

If the server halts before starting the operating system (OS), press and hold Ctrl and Alt
and press Delete. This restarts the server.
IMPORTANT:
To reset the server when it is not frozen, make sure that no processing is in progress.
!
Hard Reset
Press the RESET switch at the front of the server.
!
Soft Reset
If the server halts before starting the OS, press and hold Ctrl and Alt and press Delete.
This restarts the server.

Forced Shutdown

Use this function when an OS command does not shut down the server, the POWER
switch does not turn off the server, or resetting does not work.
Press and hold the POWER switch on the server for at least four seconds. The power is
forcibly turned off. To turn on the power back again, wait approximately 10 seconds
after turning off the power (forced shutdown).
IMPORTANT:
OS, and turn off the power again in the normal way.
Resetting the server clears the DIMM memory and the data in process.
Figure 5-1. Reset Switch
A
Figure 5-2. Power Switch
If the remote power-on function is used, cycle the power once to load the
A
Problem Solving 5-3