Removing The Server From The Rack - NEC EXPRESS5800/120Re-2 Service Manual

Removing the Server from the Rack

The system can weigh up to 55 pounds (25kg). If the system
contains numerous optional boards and peripheral devices,
it will weigh more. To avoid personal injury, at least two
persons are required to install the server into the rack.
1. Release the security lock, open and remove the front bezel. See Figure 2-31.
2. Confirm that the server is powered OFF, and disconnect the power cable and
all the interface cables connected to the server.
3. If a cable arm is installed, remove the two screws securing the cable arm to
the server and remove the cable arm from the server.
4. Loosen the two front thumbscrews (Figure 2-32, B) securing the server to
the rack.
5. Holding the handles (Figure 2-32, A), slowly and carefully pull the server
out of the rack. A click is heard as the slide rails lock in the extended
position.
Figure 2-32. Server handles and Thumbscrew Locations
2-26 Setting Up the System
!
WARNING
Figure 2-31. Opening the Front Bezel
A
B