NEC EXPRESS5800/120Re-2 Service Manual page 147

C
A
A Power Cable
B SCSI Interface Cable
C SCSI Terminator
Figure 4-48. Connecting the SCSI and Power Cables to the Backup Device
Note:
The SCSI terminator must be placed in the device bay. See
Figure 4-48, C.
20. Route the SCSI cable starting from the device, pass through the frame on the
right side of the server, and connect with the on-board SCSI.
See Figure 4-49.
A
C
A SCSI connector on the system board
B SCSI cable connected between the SCSI connector
on the system board and the backup device
C Disk array controller
D SCSI cable connected between the disk array
controller board and the SCSI backplane
Figure 4-49. Routing the SCSI Interface Cable
B
B
D
Disassembly and Reassembly 4-45