Installing The Rail Brackets Onto The Sliding Rails - NEC EXPRESS5800/120Re-2 Service Manual

Figure 2-3. Inner Rails Attached to the Server

Installing the Rail Brackets onto the Sliding Rails

1. Position a rail bracket behind each sliding rail assembly as shown in
Figure 2-4.
2. Line up the screw holes (slots) at the end of each rail assembly to the screw
holes in the rail bracket. Install two small screws (Figure 2-1, D) into each
rail bracket and loosely tighten the screws to temporarily secure the rail
assembly and bracket. See Figure 2-5.
3. When each rail bracket is installed on the rail assembly, the catch tab at the
top end of the rail bracket should point upwards like the catch tab at the
opposite end of the rail assembly. See Figure 2-5.
A
B
2-8 Setting Up the System
Figure 2-4. Positioning the Rail Bracket
C
F
A Catch
B Attached to front side of the rack
C Rail Assembly
D Rail Bracket
E Catch
F Rack Depth Adjustment Screws.
G Attached to the rear side of the rack
Figure 2-5. Installing the Rail Bracket
D E
G