Lucent Technologies Voice Terminal 8411 User Manual page 24

To program/reprogram
an AD button
To place an AD call
1
On a separate sheet of paper, write down the outside numbers,
extensions, and/or feature access codes you want to program
Note: Each AD button will hold one complete phone
number or feature access code.
2
Pick up handset
Note: If you are using the built-in speakerphone, you must
either press a call appearance button or press
before you begin Step 3.
3
If you are using an 8411 with a display, press
press the softkey below Prog
If your 8411 does not have a display or if Prog is not
available on your display, press
or Dial AD Program access code __________
4
AD xxxxx
Press to be programmed
5
Dial outside number, extension, or feature access code you
want to store
Note: If your 8411 has a display, you may be able to use the
softkeys to add special functions such as Pause, Mark, or
Wait into the telephone numbers programmed on the AD
button.
If you are programming an outside number, be sure to
include a trunk code, if applicable.
If the programmed number is associated with a list, it can be
up to 24 digits. If the stored number is NOT associated with
a list (that is, an Automatic Dialing button), it can be up to 16
digits. See your system manager if you need help.
6
Press
#
Number is stored
Repeat Steps 4 through 6 to program additional buttons
7
Hang up or press
1
Press selected AD xxxxx
2
Call is automatically dialed
Program
[confirmation tone]
Drop to end programming
[dial tone]
Speaker
Menu and then
[dial tone]
[dial tone]
[ringback tone]
21