Disassembly/Reassembly Procedures: Radio Reassembly
8.9
Radio Reassembly
This section contains instructions for reassembling the radio.
8.9.1
Reassemble the Main Sub Assemblies
8.9.1.1 Assemble Control Top Assembly (J) to Main Chassis Assembly (K)
Control Top Screws (31)
1. Verify there are no surface irregularities such as scratches or indentations on both the
Control Top Seal Grove and the Seal's mating surface on the Main Chassis
Assembly (3). Also ensure that the Control Top Seal (10) and surrounding surfaces are free of
debris and other foreign material.
2. Verify Control Top Seal is properly seated into its groove and place Control Top Assembly
onto Main Chassis Assembly as shown in
3. Torque both screws with a Torx IP8 Bit and a torque Driver to 8 in-lbs.
8.9.1.2 Assemble Knobs and Top Bezel Assembly (H)
Antenna Spanner Nut (19)
Antenna Washer (18)
1. With the Secure Lever (14) in place, slide the Control Top Bezel onto the Control Top. Ensure
that the Secure Lever is keyed correctly on the Frequency outer shaft. Use the Secure Lever
Setter to fully set the lever into place.
Figure 8-41. Control Top Bezel Assembly
Frequency Knob (13)
Frequency Shaft
Figure 8-42. Top Bezel Assembly
Control Top Assembly (9)
Figure 8-41.
Volume Knob (12)
Torque Adder (15)
Volume Spanner Nut (17)
Volume Washer (16)
Volume Shaft
Control Top Bezel Assembly (11)
Sec 1: 8-31