Sec 1: 8-38
8.9.1.10 Assemble Speaker Grille Assembly (A)
1. Install the Speaker Grille (A) by inserting the top lip under the control top bezel and rotating
the grille into place. See
NOTE: Ensure the Memory Door (33) is in place and the memory door screw shaft is
2. Insert the two center screws (29) and torque to 10 in-lbs. See
3. If removed, insert the two bottom screws (30) into the screw holes at the bottom of the radio
as shown in
NOTE: Refer to the appropriate section in this manual for reinstalling the antenna, battery,
Figure 8-55.
Figure 8-55. Remove Center Screws
aligned with the screw hole.
Center Screws (29)
Memory Door (33)
Figure 8-56. Insert Center Screws
Figure
8-57., and torque to 10 in-lbs.
Figure 8-57. Insert Bottom Screws
or any other accessory that was previously connected or attached to the radio prior
to servicing.
Disassembly/Reassembly Procedures: Radio Reassembly
Center Screws (29)
Memory Door (33)
Bottom Screws (30)
Figure 8-56.