Motorola APX 7000 Basic Service Manual page 237

Disassembly/Reassembly Procedures: Radio Disassembly
2. With a pair of pliers, grasp the Frequency Knob and pull it upward, until it is free from its shaft.
B. Remove the Volume Knob
To remove the Volume Knob (12):
1. Hold the radio in one hand so that the top of the radio faces upward and the front of the radio
faces you.
2. With a pair of pliers, grasp the Volume Knob and pull it upward.
Control Top Screws (26)
Volume Knob (12)
8.7.9 Removal of the Control Top Assembly (J)
i. Use a Torx Plus IP8 bit to remove the two Control Top Screws (26). See
NOTE: Ensure the Control Top flex is disconnected from the VOCON Board (G) to prevent
Control Top Screws (26)
II. Gently separate the Control Top Assembly (J) from the Main Chassis Assembly (K).
NOTE: Place the Control Top Assembly (J) and the remaining Main Chassis Assembly (K)
Figure 8-24. Remove Knobs and Fastener Hardware
damage to the flex or connector.
Figure 8-25. Remove Control Top Assembly
on an ESD safe surface free from debris.
Antenna Spanner Nut (16)
Antenna Washer (15)
Control Top Assembly (J)
Control Top Seal (14)
Sec 2: 8-17
Figure 8-25.