Motorola APX 7000 Basic Service Manual page 112

Sec 1: 8-24
8.8.5 Servicing of RF Board Assembly
Complete steps
RF Board Assembly (F)
8.8.5.1 Battery Seal
1. Slide the Battery Connector Seal (41) from the battery contact header with the Black Stick.
2. Use the Black Stick and push the new Battery Connector Seal until it is properly seated onto
the RF Board surface.
8.8.5.2 Thermal Pads
1. Scrape off both thermal pads (39 and 40) from the amplifiers and / or Main chassis with the
Black Stick.
2. Ensure there are no debris or residue left on the amplifier's surfaces.
3. Replace with new thermal pads.
4. Peel off the back liner from the thermal pads.
5. Insert the Outer Thermal Pad (39) into the shield opening. Make sure the bottom surface of
the pad is mating with the top surface of the amplifiers.
6. Insert the Inner Thermal Pad (40) without compressing or deforming it.
NOTE: There are no other serviceable components on the RF Board Assembly.
Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
8.7.1 through 8.7.6
Figure 8-33. RF Board Assembly
Thermal pads should always be replaced when RF Board
assembly is removed.
of Section "8.7 Radio Disassembly" on page
Battery Connector Seal (41)
1:8-12.
Inner Thermal Pad (40)
Outer Thermal Pad (39)