Motorola APX 7000 Basic Service Manual page 123

Disassembly/Reassembly Procedures: Radio Reassembly
8.9.1.7 Assemble Expansion Board Assembly (C)
Flex Connectors
1. If the Control Top Assembly (J) or VOCON Board Assembly (G, N) was NOT removed skip to
step 2.
Connect the Control Top Flex to the VOCON Board Assembly as shown in
2. If the RF Board Assembly (38) was NOT removed, skip to step 4.
Carefully align the Antenna Coax Plug to the Coax Receptacle on the RF board Assembly (F)
and slide the plug in using the Black Stick. Ensure the universal connector flex is not caught
under the antenna coax cable.
3. Tuck in the Antenna Coax Cable into its grooves as shown in
4. Plug the Expansion Board Assembly (C) to the VOCON Board Assembly (G, N) as shown in
Figure 8-48.
5. Connect the two Flex Connectors to their pairing connectors on the right and left sides of the
Expansion Board Assembly as shown in
6. If the radio is equipped with an Option Board Assembly skip this step. Install the
Connector Plug (32) by inserting it onto the Option Board Connector on the VOCON Board
Assembly as shown in
Figure 8-48. Assemble Expansion Board Assembly
Make sure the connector is fully engaged.
Figure 8-49. Insert Flex Connectors
Figure 8-48.
Connector Plug (32)
Expansion Board Assembly (42)
Antenna Coax Cable
Figure 8-48.
Figure 8-49.
Flex Connectors
Sec 1: 8-35
Figure 8-48.