Disassembly/Reassembly Procedures: Radio Disassembly
8.7.2
Removal of the Speaker Module (B)
1. Remove the top two screws (28) as shown in
2. Carefully pick out the Speaker Module (23) with the Black Stick and swing it out of the
Main Chassis Assembly (K) as shown in
8.7.3
Removal of the Expansion Board Assembly (C)
1. Using the Black Stick, unplug the two flex connectors located on the left and right side of the
Expansion Board Assembly (42). Unfold and straighten the flex located on the right side as
shown in
Port Seal (25)
Figure 8-15. Remove Top Screws
Port Seal (25)
Figure 8-16. Remove Speaker Module
Be careful not to damage the speaker cone or the Port Seal (25)
during the disassembly process.
This Module has lubricant on the seal and can be contaminated
with foreign material. Any foreign material can put the radio's
submergibility at risk.
Figure 8-17.
Figure 8-15.
Top Screws (28)
Speaker Cone
Figure 8-16.
Speaker Cone
Sec 1: 8-13