Motorola APX 7000 Basic Service Manual page 247

Disassembly/Reassembly Procedures: Radio Reassembly
8.9.1.4 Assemble RF Board Assembly (F)
1. Inspect the Battery Connector Seal (35) on the RF Board Assembly (F) for any damage or
debris. Replace seal if necessary.
2. Connect the small coaxial cable connector into the RF Board (32).
3. Connect the RF Board to the VOCON Board as shown in
NOTE: Do not connect the Antenna coax at this time. Front Housing Assembly (1) must be
RF Board Assembly (32)
Always replace with new thermal pads. See
Thermal Pads" on page
snapped in place prior to connecting the coax.
Connector
Small Coax Cable
Figure 8-40. Connect RF Board to VOCON Board
Section "8.8.5.2
2:8-22.
Figure 8-40.
VOCON Board
Sec 2: 8-27