Maintenance Messages - Kyocera Mita FS-1800 User Manual

4.3.2

Maintenance Messages

Message
Add paper (paper source)
Call service
personEn:0123456
Call service
personFn
Check waste
toner bottle
Clean printer
Press GO
Duplexer
rear cover open
Face-down tray
paper full
Load Cassette #
(paper size)/(paper type)
*(paper size) and (paper
type) are displayed flashing
alternately.
!"
:Alarm buzzer sounds when an error occurs.
The following table lists maintenance messages that can be dealt with by
the user.
The paper has run out. Supply paper according to the paper source displayed (paper
cassette, MP tray, or optional paper feeder).
Messages indicating the printer status (Ready, Please wait, Processing*,
Waiting, and Form Feed Time Out*) are displayed alternately.
* These messages will not appear if the number of copies is set to 2 or more.
Mechanical error (n=0, 1, 2, ...)-Call a service person. The printer does not operate
when a message beginning with E is displayed. The total number of pages printed is
also indicated.
Controller error (n=0, 1, 2, ...)-Call a service person. The printer does not operate
when a message beginning with F is displayed.
Replace the old waste toner bottle with the new one which is included in the TK-60/
TK-60E toner kit. The message will also be shown if the waste toner bottle has
become full. The waste toner bottle should be replaced when the message display
eventually shows Toner low TK-60. See section
!"
Replacement on page 3-2.
Please clean the inside of the printer. See section
This message will be displayed when replacing the toner container after the message
Replace toner TK-60 has been displayed. After cleaning the inside of the printer,
press the GO key and the printer will be ready for printing.
If Auto Continue is set to On, printing will be automatically resumed after a preset
period of time.
Open the option duplexer rear cover, then close tightly.
The face-down tray has become full (approx. 250 pages). You must remove all printed
pages from the face-down tray. When the printer senses that the face-down tray is
!"
empty again, it will continues printing into the face-down tray.
There is data for printing that matches with a paper cassette setting (paper size,
paper type), but there is no paper in the cassette.
Set paper into the paper source as displayed on the control panel, and press the
GO key to restart printing. However, the paper source number (#) is only displayed
when there is an optional paper feeder installed.
Or, if you want to print from a different paper source press the GO key to display Use
alternative? and you can change the source for paper feeding. Further, you can
!"
change the paper source by pressing the GO key.
After selecting a paper source and pressing the MODE key, Paper handling >
appears. By pressing the > key, the paper type settings menu appears. After setting
the correct paper type, press the ENTER key and printing starts.
Corrective Action
4-7
Indicators and Messages
3.1 Toner Container
3.3 Cleaning on page 3-9.
(Continued on next page)