Subnet Mask - Kyocera Mita FS-1800 User Manual

8
?
9
ENTER
10
11
ENTER
12
MENU
Press the > key. Each time the
item changes as shown below.
>>DHCP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
Display the setting item to be set and press the ENTER key. For
DHCP, the message display indicates a question mark (?). For IP
Address, Subnet Mask, and Gateway, the cursor ( ) blinks.
For DHCP , each time the
display changes between On and Off. For IP Address, Subnet Mask,
and Gateway addresses, pressing
(000 to 255) where the cursor is blinking. You can use the < or > key
to move the cursor back and forth through the figures to rapidly set a
large number.
If you enter the wrong number, clear it by pressing the CANCEL key,
then enter the correct number again.
Press the ENTER key.
Press the MENU key and the message display returns to Ready.
1-47
Operating the Operator Panel
key is pressed, the setting
or
key is pressed, the message
or
key changes the numbers
or