Error Messages - Kyocera Mita FS-1800 User Manual

4.3.3

Error Messages

Message
File not found
Press GO
Format error
Memory Card
Format error
Hard disk
Hard disk error##
Press GO
I/F occupied
ID error
Insert the same
memory card
!"
:Alarm buzzer sounds when an error occurs.
The following table lists error messages that can be dealt with by the user.
VMB: A virtual bin that was specified for output does not contain any jobs, or the
virtual bin is not being used. Confirm the bin.
If Auto Continue is set to On, printing will be automatically resumed after a preset
!"
period of time.
This message appears when the printer is in the ready state and the memory
(CompactFlash) card is not formatted, and therefore cannot be read or written.
Follow the procedure on section
Initialization (formatting) of the hard disk is required. Initialize the hard disk.
(Refer to section ###
Check the error code displayed in the place of and refer to the appropriate description
below.
01: Hard disk format error. If this error recurs even if the power has been turned off
and then on, reformat the hard disk.
02: The disk system is not installed. Recheck the requirements for using the system
and the devices.
03: Cannot write in the hard disk system because write protection is enabled.
Disable write protection.
04: There is no available hard disk space. Delete unnecessary files, etc., in order to
free up space.
05: The specified file does not exist in the hard disk.
06: There is no memory available to the hard disk system. Increase the available
memory.
10: Formatting is not possible because host data is being spooled on the hard disk.
Wait until the hard disk is ready, and then format.
20: The hard disk was installed in the incorrect slot. Reinstall the hard disk in a
different slot.
85: VMB; Alias error (The alias setting was lost, or the virtual bin corresponding to
the alias does not exist.) Set alias again.
86: VMB; ID error (There is no ID specified, the ID is incorrect, or the ID setting is
lost.) Confirm the correct.
97: e-MPS; The number of nonvolatile jobs reached the limit value, and no more can
!"
be saved. Either delete some unnecessary jobs, etc., or increace the limit.
This message is displayed when you attempt to use the printer's operator panel to
change the environmental settings on the interface from which data are presently
being received.
The ID entered for the virtual mail box function, a private job, or a stored job is not
correct. Check the ID that is set using the printer driver.
You have inserted the wrong memory (CompactFlash) card when the Insert again
message was displayed. Remove the wrong memory card from the printer's memory
card slot and insert the correct memory card. The printer again reads it from the
beginning of the data.
Corrective Action
### #-#
on page
on page #-#.)
4-9
Indicators and Messages
to format the card.
(Continued on next page)