Serial Interface - Kyocera Mita FS-1800 User Manual

Operating the Operator Panel
MENU
ENTER
ENTER

Serial Interface

You can set the baud rate, data bits, stop bits, parity, and protocol for the
serial interface.
1
Press the MENU key.
2
Press the
or
is indicated by one of following messages:
Parallel (default)
Serial
Option (if installed)
3
Press the ENTER key. The message display shows a blinking
question mark (?).
Interface
? Parallel
If you want to abandon the interface selection procedure, press the
CANCEL key. The interface remains unchanged.
4
Press the
or
Interface
? Serial
5
Press the ENTER key again.
1-42
key and select. Interface >. The current emulation
>
key and select Serial.
>