Cleaning The Charger Wire - Kyocera Mita FS-1800 User Manual

3.3 Cleaning
Note
3.3.1

Cleaning the Charger Wire

In addition to the maintenance procedures described on the following
pages, the charger wire in the drum unit and paper feed unit should be
cleaned from time to time, or whenever print quality problems occur.
To avoid print quality problems, the following printer parts must be
cleaned with every toner container replacement.
• If the toner container has been replaced when the message
Replace toner TK-60 was displayed, the message
Clean printer Press GO will be displayed after replacement. After
cleaning the inside of the printer following the procedure shown
below, press the GO key; the message will disappear and the printer
will be ready for printing.
• The main charger unit and grid should be cleaned when the toner
container is changed.
To avoid print quality problems due to paper dust and debris, clean the
interior of the printer in the following manner.
Open the side cover on the left side of the printer.
1
Side Cover
Pull the cleaning knob (green colored) slowly in and out a few times.
2
The charger wire inside the printer is cleaned by this procedure.
Cleaning Knob
(Green)
3-9
Main Charger
Unit
Cleaning