Memory Card - Kyocera Mita FS-1800 User Manual

Operating the Operator Panel
?
ENTER
ENTER
2
Press the
or

Memory Card

3
Press the > key.
4
Press the
or
indicates >Write Data.
>Write Data
5
Press the ENTER key. The message display shows a blinking
question mark (?).
>Write Data ?
6
Press the ENTER key. The message display changes to show
Processing, then to Waiting.If you want to abandon writing, press
the CANCEL key.
7
In this state, send the file from the computer to the printer as in the
example below.
Example:
To send the file (data) TEST.TXT on drive C, enter the following at
the DOS prompt (C:\):
COPY TEST.TXT PRN
The file is written onto the memory card given a destination name
(also referred to as a partition name) which the printer automatically
assigns one after another as follows:
DataS001 (first data), DataS002 (second data),
DataS003 (third data), ... DataS127 (last data)
In the example above, if the file TEST.TXT is the first data to be
written onto the memory card, the destination name will be
DataS001.
As the printer receives data, the message display changes to
Processing, then when the end of the data is received, the message
display changes to Waiting.
1-80
key and select Memory card >.
>
key repeatedly until the message display