Operator Panel; Message Display - Kyocera Mita FS-1800 User Manual

Operator Panel

1.1 Operator Panel
INTERFACE

Message Display

The message display gives information in the form of short messages. The
six messages listed below are displayed during normal warm-up and
printing.
Message
Self test
Please wait
Ready
Processing
Waiting
Sleeping
Cancelling data
FormFeed Time Out
Other messages appear when the printer needs the operator's attention as
Chapter
explained in
Interface Indicator
The interface indicator shows which of the printer's interfaces is currently
active. It uses the following abbreviations:
The interface is not specified
---
Standard bi-directional parallel interface
PAR
Serial interface (RS-232C)
SER
Option network interface card
OPT
The PAR, SER, or OPT indicator flashes when the printer is receiving and
has received all the data, and then remains on.
The printer is self-testing after power-up.
The printer is warming up and is not ready.
The printer is ready to print.
The printer is receiving data, generating graphics,
reading an memory card, or printing.
The printer is waiting for a command that says the
job is over before printing the last page. Pressing
the GO key allows you to obtain the last page
immediately.
The printer is in Sleep mode. The printer wakes
from Sleep mode whenever a key on the control
panel is pressed, the cover is opened or closed, or
data is received. The printer then warms up and
goes online. (The time that it takes the printer to
enter Sleep mode depends on the Sleep Timer
setting.)
Data inside the printer is being canceled.
The printer prints the last page after a waiting
period.
4.
1-2
Meaning