Network Setup (Lan Cable Connection) - Utax CD 1242 Instruction Handbook Manual

Preparation before Use

Network Setup (LAN Cable Connection)

The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP
(IPv4), TCP/IP (IPv6), IPX/SPX, NetBEUI, IPSec, and AppleTalk. It enables network printing on the Windows,
Macintosh, UNIX, NetWare and other platforms.
This section explains the TCP/IP (IPv4) Setup and AppleTalk Setup procedures. For other network settings,
refer to the Network Setup on 8-64.
• TCP/IP (IPv4) Setup...2-12
• AppleTalk Setup...2-14
NOTE:
If user login administration is enabled, you can only change the settings by logging in with
administrator privileges. If user login administration is disabled, the user authentication screen appears. Enter
a login user name and password, and press [Login]. Refer to Adding a User on page 11-5 for the default login
user name and password.
TCP/IP (IPv4) Setup (by Entering IP Addresses)
Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway
addresses. The default settings are "TCP/IP Protocol: On, DHCP: On, Bonjour: Off, Auto-IP: On".
NOTE:
Prior to the IP address entries, obtain permission from the network administrator.
Use the procedure below.
System - IPv4
Set TCP/IP (IPv4).
IP Address
Subnet Mask
Default
Gateway
Off
On
DHCP Bonjour
Status
2-12
0.0.0.0
0.0.0.0
0.0.0.0
On
Auto-IP
Cancel
OK
08/08/2009
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3
Press [Change] of TCP/IP.
4
Press [On] and then press [OK].
5
Press [Change] of IPv4.
6
Press [DHCP].
10:10
7
Press [Off] of DHCP and then press [OK].
8
Press [Bonjour].
OPERATION GUIDE