Output Destination - Utax CD 1242 Instruction Handbook Manual

Copying Functions

Output Destination

You can use the procedure below to select an output destination such as the optional document finisher for your
copies.
NOTE:
Optional output destinations include the job separator, built-in finisher, document finisher, 3,000 sheet
document finisher, and mailbox.
The table below shows the available output destinations.
Destination
Top tray
Finisher Tray*
Tray A, Tray B*, Tray C*
Job Separator Tray
Tray 1 to 7*
* Copy output orientation can be selected either as face-up (print facing up) or face-
down (print facing down).
NOTE:
To change default destination for copies, refer to Paper Output on page 8-14 for details.
Use the procedure below to select the output destination.
Ready to copy.
Paper Output
Place original.
Top Tray
Original : ---
Job Separator
Zoom : 100%
Tray
Paper : ---
Tray 4
Preview
Add Shortcut
Status
4-12
Top tray of the machine (where copies are stored)
Tray of the optional built-in finisher or document finisher
Trays A to C in the optional 3,000 sheet document finisher
Optional job separator
Trays 1 to 7 in the optional mailbox (tray 1 is the top tray)
Copies
Face Up
Face Down
Tray A Tray B Tray C
Tray 2 Tray 3
Tray 1
Tray 6 Tray 7
Tray 5
Cancel OK
08/08/2009
Description
1
Press the Copy key.
2
Place the originals on the platen.
3
Press [Org./Paper/Finishing] and then [Paper
Output].
4
Select the output destination for finished copies.
When you select [Finisher Tray], [Tray B], [Tray C]
or [Tray 1] to [Tray 7], select the orientation of
output copy, Face Up (print facing up) or Face
Down (print facing down).
5
Press [OK].
10:10
6
Press the Start key to start copying.
OPERATION GUIDE