Utax CD 1242 Instruction Handbook Manual page 251

NOTE:
Refer to page 4-17 and page 5-23 for Border Erase.
Use the procedure below to specify the border erase setting for the back of the page.
1
Press the System Menu key.
2
Press [Common Settings], [
Page.
3
Press [Same as Front Page] or [Do Not Erase].
4
Press [OK].
Margin Default
Set the default margin. The table below shows the measurement ranges that can be set.
Input units
Inch
Metric
Use the procedure below to set the default margin width.
1
Press the System Menu key.
2
Press [Common Settings], [
3
Use the [+] or [-] to enter the margin widths for Left/Right and Top/Bottom.
You can use the numeric keys to enter the number directly.
4
Press [OK].
Auto Image Rotation
Select the default Auto Image Rotation setting. The table below shows the available settings.
Item
Off
On
NOTE:
Refer to page 4-32 for Auto Image Rotation.
Use the procedure below to set the default Auto Image Rotation settings.
1
Press the System Menu key.
2
Press [Common Settings], [
OPERATION GUIDE
], [Next] of Function Defaults, [
-0.75 to 0.75" (in 0.01" increments)
-18 mm to 18 mm (in 1 mm increments)
], [Next] of Function Defaults, [
No Auto Image Rotation performed.
Auto Image Rotation performed.
], [Next] of Function Defaults, [
Default Setting (System Menu)
] and then [Change] of Border Erase to Back
Range
] and then [Change] of Margin Default.
Description
] and then [Change] of Auto Image Rotation.
8
8-21