Bridge Interfaces - ZyXEL Communications UAG5100 User Manual

Table 74 Configuration > Network > Interface > VLAN > Edit (continued)
LABEL
Enable Logs for
IP/MAC Binding
Violation
Static DHCP
Table
Add
Edit
Remove
#
IP Address
MAC
Description
MAC Address
Setting
Use Default MAC
Address
Overwrite
Default MAC
Address
Related Setting
Configure
WAN_TRUNK
Configure Policy
Route
OK
Cancel

10.6 Bridge Interfaces

This section introduces bridges and bridge interfaces and then explains the screens for bridge
interfaces.
Chapter 10 Interfaces
DESCRIPTION
Select this option to have the UAG generate a log if a device connected to this VLAN
attempts to use an IP address that is bound to another device's MAC address.
Configure a list of static IP addresses the UAG assigns to computers connected to the
interface. Otherwise, the UAG assigns an IP address dynamically using the interface's
IP Pool Start Address and Pool Size.
Click this to create a new entry.
Select an entry and click this to be able to modify it.
Select an entry and click this to delete it.
This field is a sequential value, and it is not associated with a specific entry.
Enter the IP address to assign to a device with this entry's MAC address.
Enter the MAC address to which to assign this entry's IP address.
Enter a description to help identify this static DHCP entry. You can use alphanumeric
and ()+/:=?!*#@$_%- characters, and it can be up to 60 characters long.
This section appears when Interface Type is external or general. Have the interface
use either the factory assigned default MAC address, a manually specified MAC address,
or clone the MAC address of another device or computer.
Select this option to have the interface use the factory assigned default MAC address.
By default, the UAG uses the factory assigned MAC address to identify itself.
Select this option to have the interface use a different MAC address. Either enter the
MAC address in the fields or click Clone by host and enter the IP address of the device
or computer whose MAC you are cloning. Once it is successfully configured, the address
will be copied to the configuration file. It will not change unless you change the setting
or upload a different configuration file.
This section appears when Interface Type is general.
Click WAN_TRUNK to go to a screen where you can set this VLAN to be part of a WAN
trunk for load balancing.
Click Policy Route to go to the screen where you can manually configure a policy route
to associate traffic with this VLAN.
Click OK to save your changes back to the UAG.
Click Cancel to exit this screen without saving.
UAG Series User's Guide
181