Bridge Interfaces; Bridge Overview - ZyXEL Communications UAG2100 User Manual

Table 58 Configuration > Network > Interface > VLAN > Edit (continued)
LABEL
Enable Logs for
IP/MAC Binding
Violation
Static DHCP
Table
Add
Edit
Remove
#
IP Address
MAC
Description
Related Setting
Configure
WAN_TRUNK
Configure Policy
Route
OK
Cancel

10.6 Bridge Interfaces

This section introduces bridges and bridge interfaces and then explains the screens for bridge
interfaces.

Bridge Overview

A bridge creates a connection between two or more network segments at the layer-2 (MAC
address) level. In the following example, bridge X connects four network segments.
Chapter 10 Interfaces
DESCRIPTION
Select this option to have the UAG generate a log if a device connected to this VLAN
attempts to use an IP address that is bound to another device's MAC address.
Configure a list of static IP addresses the UAG assigns to computers connected to the
interface. Otherwise, the UAG assigns an IP address dynamically using the interface's
IP Pool Start Address and Pool Size.
Click this to create a new entry.
Select an entry and click this to be able to modify it.
Select an entry and click this to delete it.
This field is a sequential value, and it is not associated with a specific entry.
Enter the IP address to assign to a device with this entry's MAC address.
Enter the MAC address to which to assign this entry's IP address.
Enter a description to help identify this static DHCP entry. You can use alphanumeric
and ()+/:=?!*#@$_%- characters, and it can be up to 60 characters long.
Click WAN_TRUNK to go to a screen where you can set this VLAN to be part of a WAN
trunk for load balancing.
Click Policy Route to go to the screen where you can manually configure a policy route
to associate traffic with this VLAN.
Click OK to save your changes back to the UAG.
Click Cancel to exit this screen without saving.
UAG2100 User's Guide
133