Table of Contents
Advertisement
3. Insert the new module with the product label facing upwards. When the module is almost
inserted, push until you hear a "click" that indicates that the module is locked in place. Verify
that the module is locked in place by pulling gently on the extraction handle: the module must
not move.
4. Attach the new module to the electrical supply:
-
AC mains supply: connect the mains cable
48VDC supply: plug in the supply cable's connector 1. Verify that the connector is locked in
-
place by pulling it gently.
Each PSU module is equipped with a light showing its state (two colours: green/red):
Module working correctly
-
module connected to a power source but not installed in a firewall: green, blinking.
SN6000 (halted):
-
module installed but not connected to a power source, and the other module is installed and
connected: green, blinking.
-
module installed and connected to a power source: green, blinking.
SN6000 (running):
-
module installed and connected to a power source: green, not blinking.
-
module installed and not connected to a power source: red (AC mains)/not lit (48VDC), not
blinking (+buzzer).
Module not functioning correctly
-
module connected to a power source: red, not blinking.
Page 56 /59
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
APPENDIX G: CHANGING A POWER SUPPLY MODULE (SN3000 AND SN6000)
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
Hide quick links:
Advertisement
Table of Contents
